Vaporizzatore elettrico in sgfc

Coltivazione e conservazione di funghi e tartufi
Rispondi
Avatar utente
gibran
Messaggi: 35
Iscritto il: lun gen 04, 2021 8:15 pm

Vaporizzatore elettrico in sgfc

Messaggio da gibran » lun gen 04, 2021 8:24 pm

Secondo voi inserendo un vaporizzatore/umidificatore ad ultrasuoni nella sgfc, riesco a gestire l'umidità in maniera automatica? Qualcuno l'ha già fatto?


Avatar utente
asklepios
Messaggi: 3489
Iscritto il: mer gen 01, 2020 7:56 pm

Re: Vaporizzatore elettrico in sgfc

Messaggio da asklepios » lun gen 04, 2021 10:17 pm

Non saprei, ma perché complicarsi la vita. Come vai in bagno per lavarti i denti due volte al giorno si trova il tempo per dare una spruzzata

Avatar utente
gibran
Messaggi: 35
Iscritto il: lun gen 04, 2021 8:15 pm

Re: Vaporizzatore elettrico in sgfc

Messaggio da gibran » lun gen 04, 2021 10:38 pm

Hai ragione il fatto è che avendo casa un po' freddina diciamo un po' sotto i 20 ho messo una serpentina da rettilario da 50w una decina di cm sotto la sgfc ed ho paura che secchi troppo l'aria. Cmq l'unica è aspettare domani, visto che ho messo oggi le torte e nel caso correggere il tiro.

Avatar utente
gibran
Messaggi: 35
Iscritto il: lun gen 04, 2021 8:15 pm

Re: Vaporizzatore elettrico in sgfc

Messaggio da gibran » lun gen 04, 2021 10:42 pm

Cmq ieri con l'umidificatore messo all'interno della sgfc vuota, riuscivo ad avere un'umidita' costante sull'85 % a 25°C e le pareti erano tutte bagnate


Avatar utente
asklepios
Messaggi: 3489
Iscritto il: mer gen 01, 2020 7:56 pm

Re: Vaporizzatore elettrico in sgfc

Messaggio da asklepios » mar gen 05, 2021 11:10 pm

Stavo cercando per altro e ho ritrovato questo articolo di cui ti suggerisco la lettura. Cito alcune frasi:
Many new growers would like automation in their fruiting chambers. Misting and fanning is really no hassle. If you have time to brush your teeth you have time to mist a few cakes. Naturally most new growers are excited about their project and check on their cakes too much any way. Still the idea of automation persists.

Fanning is almost pointless. The fanning is accomplished by simply removing the lid to mist. Fanning a SGFC (which gets automated FAE 24/7 because of the hundreds of holes) is like rolling a window down on a motorcycle.

Attaching humidifiers or air pumps to a SGFC will FUCK IT UP.

Using a hygrometer will make you MAKE MISTAKES. you cannot accurately measure cake surface humidity. The humidity needs to be 90+ percent only an inch from the surface of the cake ad the evaporate into the "medium humidity" air in the SGFC. this air space can be 50-80% and fluctuate. This air space is more humid than your room air and less humid than the surface of the cakes. When you put a hygrometer into a SGFC it's usually mounted near holes and will read an inaccurate number. You will mist using the gauge as a guide and not your eyes. This will cause water logged cakes and poor performance.
You do not need to measure humidity with a hygrometer at all to achieve great performance

What you know about Temperature ranges for Cubensis might be OUTDATED
68-72F is a good temperature range for colonization(incubation) and fruiting. Warm temperatures encourage contaminants so room temperature is encouraged. 65-75 degrees requires no temperature adjustments for colonization or fruiting.
Cubensis mycelium grows as fast as it will from about 75-81 degrees. at above 81-83F speeds are reported to decline again. Below 65F cubensis mycelium will grow but at a slower pace until just before 32F when it will stall. Cubensis doesn't tolerate freezing but jars may be stalled in a fridge for later fruiting once they are fully colonized.

Avatar utente
gibran
Messaggi: 35
Iscritto il: lun gen 04, 2021 8:15 pm

Re: Vaporizzatore elettrico in sgfc

Messaggio da gibran » mer gen 06, 2021 10:57 am

Grazie per il rassicurante articolo. La paura era che fosse poco vaporizzare solo al mattino e la sera visto che al mio ritorno le torte sono completamente asciutte. Tra l'altro leggendo il consiglio di spruzzare dalle 3 alle 6 volte al giorno.

Avatar utente
asklepios
Messaggi: 3489
Iscritto il: mer gen 01, 2020 7:56 pm

Re: Vaporizzatore elettrico in sgfc

Messaggio da asklepios » mer gen 06, 2021 1:19 pm

Tieni presente che la maggior parte dell'acqua è già all'interno, l'hai fornita nel momento in cui hai preparato il substrato e nel momento in cui hai fatto il dunking. Spruzzare serve solo ad evitare che la superficie si secchi troppo (se succede te ne accorgi perché diventa bluastra) e la continua evaporazione superficiale favorisce la formazione dei primordi. Comunque vedi, addirittura nell'articolo parla di 18 °C, quindi a meno che non hai 10 gradi in casa non mi preoccuperei troppo della temperatura, al massimo ci vorrà un po' di più. Tieni anche presente che il micelio produce il suo stesso calore, quindi le tortine saranno 2/3 gradi in più rispetto all'ambiente

Rispondi